At the dismantling site of the scrapped vehicle, the Excavator removal shear, grab fork and suction cup are often replaced and used, which involves the installation and disassembly of the equipment. For the installation and disassembly of the Excavator removal shear, there are certain operating procedures that need to be followed. The following will introduce how to disassemble the disassembly shear correctly.

Excavator removal shear removal method:
1. Move the excavator to an open and flat place, and pay attention to the fact that there should be no water vapor, dust and sludge in the air that easily pollute the hydraulic oil and other sundries. Shut off the engine of the equipment and release the internal pressure first if the hydraulic cylinder is pressurized.
2. Rotate the stop valve assembled to the excavator by 90 degrees to prevent the hydraulic oil from flowing out.
3. Remove the hose connector on the excavator, recover the outflowing hydraulic oil, and then put it back into the hydraulic oil tank.
4. Avoid mixing dust, sludge and other substances into the oil pressure pipeline, and then seal the hose and pipeline with hose plugs and integrated covers to keep the oil system clean. At the same time, secure the high and low pressure hoses to avoid contamination.
5. When removing the dismantling shears from the excavator, pull out the two pins connecting the equipment and the boom. The dismantling shears should be placed on the board to isolate them from the ground, and cover the outside as much as possible.
6. When the Excavator removal shear is not used for a long time (more than three weeks), the outside of the equipment should be cleaned first, then the drill rod should be removed and coated with anti-rust oil before being placed. The remaining parts are injected with lubricating oil before the drill rod Put it back.
The above is the entire process of Excavator removal shear removal. When reassembling the removal shear for operation, just reverse the above procedure. It should be noted that when excavators and other construction machinery carry out other operations, the hoses and pipes will be contaminated with soil and other pollutants, so before installing and disassembling the shears, the hydraulic pipes and joints should be cleaned.