NEWS / Upin Home
How Excavator removal shear works
- Categories:Industry News
- Author:
- Origin:
- Time of issue:2023-01-31
- Views:0
(Summary description)At the dismantling site of scrapped vehicles, hydraulic dismantling shears, grabbing forks and suction cups are often replaced, which involves the installation and disassembly of equipment. For the installation and disassembly of the Excavator removal shear, there are certain operating procedures that need to be followed.
How Excavator removal shear works
(Summary description)At the dismantling site of scrapped vehicles, hydraulic dismantling shears, grabbing forks and suction cups are often replaced, which involves the installation and disassembly of equipment. For the installation and disassembly of the Excavator removal shear, there are certain operating procedures that need to be followed.
- Categories:Industry News
- Author:
- Origin:
- Time of issue:2023-01-31
- Views:0
At the dismantling site of scrapped vehicles, hydraulic dismantling shears, grabbing forks and suction cups are often replaced, which involves the installation and disassembly of equipment. For the installation and disassembly of the Excavator removal shear, there are certain operating procedures that need to be followed. The following will introduce how to install and disassemble correctly.
How to install and remove Excavator removal shear
1. Move the excavator to an open and flat place, and pay attention that there should be no water vapor, dust, sludge and other sundries in the air that are easy to contaminate hydraulic oil. Shut off the equipment engine, if the hydraulic cylinder is pressurized, release the internal pressure first.
2. Rotate the cut-off valve assembled to the excavator 90 degrees to prevent hydraulic oil from flowing out.
3. Remove the hose connector on the excavator, recover the outflowing hydraulic oil, and then put it back into the hydraulic oil tank.
4. Avoid allowing dust, sludge and other substances to mix into the oil pressure pipeline, and then seal the hose and pipeline with the hose plug and integrated cover respectively to keep the oil system clean. At the same time, secure the high and low pressure hoses to avoid contamination.
5. When removing the demolition scissors from the excavator, just pull out the two pins connecting the equipment and the boom. The disassembled shears should be placed on the wooden board to isolate it from the ground, and cover the outside as much as possible.
6. When the Excavator removal shear is not used for a long time (more than three weeks), the outside of the equipment should be cleaned first, then the chisel should be removed and coated with anti-rust oil, and the rest of the parts should be filled with lubricating oil before the chisel put it back.
The above is the whole process of removing the Excavator removal shear. When reinstalling the removal shear, you only need to reverse the above procedure. It should be noted that when construction machinery such as excavators perform other operations, the hoses and pipes are easily contaminated with dirt and other pollutants, so the hydraulic pipes and joints should be cleaned before installing and disassembling the shears.
Scan the QR code to read on your phone
Relevant information

Rigorous testing
Excellent price-quality ratio & performance

24/7 Online services
Satisfying After-sales Service

On time delivery
Strong production capacity

Quality qualification
Low operating & maintenance costs

CONTACT US
Weifang VYE Machinery Co. LTD.
Address: Middle Section of Xihuan Road, Weifang City, Shandong Province
Email: 13070739113@vye.cn
Copyright © Weifang VYE Machinery Co. LTD. Powered by www.300.cn 鲁ICP备20003387号-4