The application of Hydraulic Rotating Scrap Steel Eagle Shear for Excavator in scrap vehicle dismantling and scrap metal processing is becoming more and more popular. With its strong shearing force, it can easily process metal materials such as scrap steel and scrap iron. Although the structure of the olecranon scissors is solid and the materials used for manufacturing are of high strength, there are also precision components such as hydraulic cylinders and transmissions inside. Some wrong and bad operations will greatly increase the failure rate of the equipment.

Five prohibited behaviors of Hydraulic Rotating Scrap Steel Eagle Shear for Excavator:
1. It is strictly forbidden to use olecranon scissors for hammering operations
The olecranon scissors are not a whole piece of iron like a breaking hammer. There are precision parts such as hydraulic cylinders, electrical control devices, and transmission control devices inside. Although the shell material is strong, it can prevent certain collisions. Violent impacts can cause these components to become damaged and no longer function properly. In addition, the cutting edge and each movable shaft at the front end of the Hydraulic Rotating Scrap Steel Eagle Shear for Excavator are also precisely matched, so it is easy to deform its structure when hammered.
2. It is strictly forbidden to use olecranon scissors for tearing operations
Many operators like to use excavator olecranon scissors to tear materials, but this wrong operation can easily lead to damage to the excavator arm cylinder, and in severe cases, it can directly cause the piston rod of the arm cylinder to break on the spot, endangering the safety of personnel and vehicles. In addition, this operation is also easy to loosen the bolts of the olecranon scissors, which is not used for subsequent use.
3. It is strictly forbidden to use olecranon scissors for sweeping operations
In order to save trouble, some operators like to use the olecranon scissors to move the waste aside while cutting. This operation is also easy to damage the equipment. This is because the operator cannot judge the distance between the cutting blade and the ground every time. When the cutting blade touches and rubs against the ground, it will cause varying degrees of damage to the rotating connection bearings, motors, and gears of the olecranon shears.
4. It is strictly forbidden to use the olecranon scissors to swing the car with a pestle
"Punching the car" is an operation familiar to excavator drivers. Compared with the traditional turning method, it can be faster and looks cool. There is a high probability of damage to the slewing rings, motors and gears.
5. It is strictly forbidden to operate the motor for twisting during cutting
Hydraulic Rotating Scrap Steel Eagle Shear for Excavator can be rotated 360 degrees, which is convenient for shearing at any angle, but we must not operate the motor for twisting while shearing. Because the olecranon scissors are medium-sized, a large motor cannot be installed inside, and it can only satisfy the cutting blade rotation under no-load conditions. If it is rotated while cutting, the motor will be overloaded, which will easily cause damage to the motor and transmission gear. damage.
The above five points are prohibited in the daily operation of Hydraulic Rotating Scrap Steel Eagle Shear for Excavator. Go into the olecranon scissors to avoid unnecessary damage to the equipment.